金属切削仿真中采用自适应网格时出现不能使用单元畸变控制
本帖最后由 hlhchina 于 2011-11-30 21:38 编辑我在做金属切削仿真,在金属切削仿真中采用自适应网格,但是在网格检查时出现自适应不能使用单元畸变控制!!!
问题描述如下:
Adaptive meshing is not supported for elements used with the distortion control.
Domain name: assembly_adapt
Abaqus/Explicit Packager exited with an error - Please see thestatus file for possible error messages if the file exists.
但是不用网格畸变控制吧,又出现了网格畸变问题:
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
Print-out suppressed for subsequent distorted elements
There are a total of 60 excessively distorted elements.
请求各位达人帮助,万分感谢!!!
有人回复吗
老哥,您这个问题解决了吗?
页:
[1]