求翻译

jackline · 发表于 2011-6-30 00:03:22

外语不精，求达人翻译，谢谢

1：垂直度超差：图纸要求Φ125±0.011外圆和端面的垂直度公差0.03mm,实测0.06mm

2：平行度超差：图纸要求部件底部装配基准面与装导轨平面平行度0.02mm，实测0.05mm
3：直线度超差：实测导轨止口直线度0.26mm（中凹）
4：尺寸超差：图纸要求 Φ150+0.04孔中心线与底面尺寸为145±0.03mm,实测144.94mm
5：装配基准面有2处补焊，凸0.03mm（长15mm宽5mm）附照片

神奇宝贝 · 发表于 2011-7-5 11:16:19

1.Perpendicularity is out of tolerance: drawing's requirement is Φ125±0.011, perpendicularity tolerance of the outer circle and end face is 0.03mm, fact measurement is 0.06mm.
2. Parallelism is out of tolerance: the required parallelism between the bottom assemble datum plane and guide installiaton plane is 0.02mm, fact measurement is 0.05mm.
3. Straightness is out of tolerance: fact measurement of the guide's front edge is 0.26mm(Middle is concave)
4. Dimension is out of tolerance: drawing's requirement is Φ150+0.04, distance between the hole center and the bottom is required 145±0.03mm, fact measurement is 144.94mm.
5. There are two repair-welding on the assemble datum plane, protruding 0.03mm(15mm long and 5mm wide), see attached photo.

jackline · 发表于 2011-7-7 20:06:32

回复 jackline 的帖子

受益匪浅，灰常感谢

还想问个问题：尺寸超差，可以用 Dimension is undersize/oversize,或dimension is not correct表示吗？

神奇宝贝 · 发表于 2011-7-8 12:37:40

jackline 发表于 2011-7-7 20:06 4 L& X/ Y0 O* y5 H2 ?
回复 jackline 的帖子& O* l4 v* v( Z! m' c& @

' r9 I9 U9 i: X" `. A% G受益匪浅，灰常感谢

没用过，也没听别人这样用过

采彡铯莎氵莫 · 发表于 2011-9-13 08:18:51

是和公司有关的，又学习了

wugqtop · 发表于 2011-9-23 13:42:19

jackline 发表于 2011-7-7 20:06 ! k0 ]: {, u8 q' d' b) \0 W. U
回复 jackline 的帖子# |& i: x6 P: u# d; b2 Z1 S j( L

0 K) E1 s# J5 Y, X! f; M3 D; E* v9 U受益匪浅，灰常感谢

dimension out of tolerance

kason127 · 发表于 2011-9-26 17:16:44

用google翻译好了！！

		自动登录	找回密码
密码			注册会员