|
|
牧野机床出现以下问题，哪个大神帮忙解决。多谢了！
$ b* ]6 h5 K t6 J# G& f0 b/ `1 w5 i5 p2 k' H1 W* c; r! {
机床问题：$ `2 U9 f z; E% H+ j" Y% ^
- x# |9 y- h; b1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED
! X' P3 L4 {4 n0 n
* t9 A4 I- ? r4 k+ RCOMMAND S—CODE AFTER RESET ALARM
. ~& s2 e1 {, _4 T$ w, h, y5 ~. [/ b/ r: i6 j
2、NOZZLE CLANT THERMAL RELAY IS TRIPPED- [% ^9 _+ j. k, U7 C* @* m! [
+ d& m- N5 [3 m! p/ W7 NDI SIGNAL TH2... WENT ON+ ^- U6 q4 z! R* @0 J" Y
# L) l' O2 F. S/ b, J+ W; d
CHECK THERMAL RELAY AND THE BREAKER
+ ^3 L: u& S5 Q& t( I' N. c; Y5 y4 Q3 X
3、NC ALAMRE IS BEING GENERATED
( M( n% x' c5 B) \8 Z# i+ w! q8 R, N( D" L" D3 t
BMI SIGNAL AL....IS ON
) Q# R% u4 O6 @# L* g( R2 M7 Z7 T( T% N# }/ p5 `9 K i
CHECK FAULTY DEVICE5 S9 Q7 J7 T# d# w, V
% B1 M8 w" ~3 O$ {% _4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF$ I( E; D8 _$ r/ r( R1 F+ t/ N
* r" M, V; J8 I4 ?: s0 \1 r2 ?CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC: @5 k7 J! X2 ~) F6 _: q6 v
) i, D. c0 U8 L' g9 u- |5 a j$ T
5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE3 R" {. @$ \+ T. D" R2 E
: D8 w1 n& e {, vSELECT CORRECT CODE, ]! b; I9 ?( I8 u/ P: O
|
评分
-
查看全部评分
|
发表于 2015-7-30 16:52:32
QQ好友和群
收藏
淘帖
问题专业，描述清楚
伸手党/灌水/看不懂