The main challenge I faced with this project was to ensure the unit would not fall over when the top is fully extended therefore using SOLIDWORKS Simulation I was able to work out how much, if any, of the unit top would deform when fully extended and analyse if the centre of mass would need adjustment. Rather than reinventing the wheel I was able to download standard drawer slides from a 3D library which imported into the SOLIDWORKS Assembly to check the fit using off the shelf components.
- L* z# m- _- z/ k9 x这个项目的挑战是确保影音台的顶部完全拉伸出来时，不会倾翻。所以使用solidworks simulation计算变形量。而且可以从3D库中拖拉出合适的抽屉滑轨导入到solidworks装配体中进行验证。
2 @; y- r1 ?& A0 @% [! N, t
: `; y' g- Y+ s# o5 ^! E8 g7 H! j! {1 ~+ N5 S! g
# j& v' B9 Y& W. P ` , C/ j7 @2 w2 {7 I4 y2 J( v" V
9 _0 J$ D: h8 {
As part of the design brief I wanted the shelves to be adjustable in order to allow media equipment such as a Freeview/satellite box and more importantly a Sonos Play 5 to be able to fit within the unit, with the help of SOLIDWORKS I was able to check the fit of the components when assembled. * J- s% }% i# Z/ t2 m0 [
作为外观设计的一部分，作者需要在影音台下面旋转低音炮音箱，和一个多媒体卫星信号转换器，在solidworks的帮助下，作者可以检查零件和组装。/ d0 ?$ f, Y9 H* ?
" F* a, W: |* E# a5 ^) q. I2 z2 L J
I consulted Andy Fitzgerald, a freelance Cabinet Maker & Furniture Designer, who advised me on a couple of design tweaks which made it more cost effective and simplistic to build and operate – the benefits of using SOLIDWORKS meant I could do this quickly and easily without building any prototypes, saving time and money. We agreed a design and Andy bought it to life, manufacturing the table primarily in fibreboard and solid maple sprayed white with polyurethane lacquer to a satin finish.$ r, k! ]9 G! P% E7 i
作者咨询了一个橱柜制造商，在其帮助下，终于打造出了这个影音台，材质为纤维板，并用白色聚氨酯漆来磨光。
5 Y5 Q: [+ U3 x' l* |9 x; w下面是影音台在房间的布置
& |3 ?# G1 H6 p4 s) X! K
( P' Y; ]2 C7 y3 G) b1 C
% \3 u# D9 [5 z9 v | 
发表于 2015-3-29 19:27:58
QQ好友和群
收藏
淘帖
问题专业，描述清楚
伸手党/灌水/看不懂
楼主
