|
本帖最后由 hlhchina 于 2011-11-30 21:38 编辑 " k: \, t6 `# n2 p* T7 o) C
+ y4 c H6 o* x3 n
我在做金属切削仿真,在金属切削仿真中采用自适应网格,但是在网格检查时出现自适应不能使用单元畸变控制!!!' l5 T5 O, T# A3 Q( K, ?
问题描述如下:! y2 v: T7 V I: `4 B
Adaptive meshing is not supported for elements used with the distortion control. / K2 G: U Z* m
Domain name: assembly_adapt$ u, G5 X3 @6 h7 p
Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.
+ X2 f; s1 G- o
, Z% E' `! y6 D) J) [# r- I) C( n- Q但是不用网格畸变控制吧,又出现了网格畸变问题:1 L7 C; W, }0 I6 R
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.! c7 @/ ^- B, C0 ]$ n
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
4 m Q! l9 s; h$ E2 XPrint-out suppressed for subsequent distorted elements) F6 I9 V) H; l4 I
There are a total of 60 excessively distorted elements.
/ Q3 v+ ~" _. b$ V请求各位达人帮助,万分感谢!!!% J9 Q' R5 v/ \& _! w
|
|