|
technical characteristics 技术参数
; X; @3 u8 \4 `( q1/intended for transportotion of barreis with titanium sponge 想用来传输钛海绵6 b8 W3 I* I9 }: L8 I2 z
2/width of operation zone,mm-860 作业宽度860毫米
3 w2 N8 b3 X8 b, `6 T/length of operation zone,mm-2600 作业长度2600毫米
( K- d& [. E9 h8 \ `4/type-powered conveyor 形式-电动输送带
! }% d* R. d# h1 J# o) J5/reverse operation mode 可以反转
2 A% i& |6 T0 Q$ L) G+ E7/conveying speed of a unil load m/s-0.02-0.25 担搁负载时速度.02-0.25米/秒
) a( j8 j( B; d! t" k) o9/drive installed power-1.1KW6 驱动1.1千瓦
0 C- c3 X6 |" T$ g: }6 V) E10/overall dimensions, length-1000 width-1250 height-470 总尺寸长1000 宽1250 高470毫米: R2 G z3 B; ^# T
technical requirements 技术要求8 J* F% h0 W6 f/ {9 B8 Q; j! c" @
1/roller conveyor(roll-tabie)shall comprise the following equipment:滚动输送带(辊子工作台)应包含下列设备:
8 r0 q) ]( D1 C( U2 W# f1.1limit switches 限位开关
* ^1 H- v+ O& L" k1.2emergency stop switches 急停开关
4 F) ?; Q4 T5 I s4 S8 L8 E2/start-up and protective equipment shall be supplied in a set 启动和保护装置应成套供应- H: G5 n8 ]5 a0 m/ r* a6 M
3/start-up and protective equipment shall be mounted on a frame(panel) 启动和保护装置应安装在一个架子或面板上
( |3 G. @5 H9 s, ~# g8 aframe size shall be provided to mount frame with equipment in the switchboard room cabinet 架子的尺寸应可以固定支架安装到控制房的控制柜上
6 L9 y9 [8 V9 |& E6 G% L* J4/local manual contral and remote automatic contral shall be provided in the start-up equipment control circuit. equipment status signais shall be issued in party B APCS 现场手动控制和远程自动控制应提供在启动设备的控制板上. 设备状态信号应提供到"party B APCS "(不清楚)2 {; x* S7 D( [0 Y
5/provide local contral desk, IP54 equipped with mode switch for "L"(local)and"R"remote operation modes. 提供现场控制台 "IP54"(不清楚)提供现场和远程控制的转换开关.
! z2 [1 q1 ]4 j5 N) T7 b1 V! z O
不是很专业,希望能帮上你! |
|