|
|
牧野机床出现以下问题，哪个大神帮忙解决。多谢了！. F2 N3 n' C" i% q! ~
/ ]1 H2 r1 @ a7 u1 l) @2 z. s7 c1 V
机床问题：
7 ]5 g" [- B: h' L- [' [$ N# ?4 j" U2 v5 @
1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED3 h& e9 |" y, x1 M, @6 G: n
+ b6 f: r6 I7 }; f5 U$ J
COMMAND S—CODE AFTER RESET ALARM( w; v# S6 P4 ^6 Z- l3 S5 E
. C1 T! B9 Y" T' G* ]9 O( B2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
% T& y* N' O1 i4 a; H* u
, e; F6 i6 k1 w/ JDI SIGNAL TH2... WENT ON! ]1 ]5 r% o) C) H0 E
( a; a7 R1 F8 Q% T& _
CHECK THERMAL RELAY AND THE BREAKER7 v7 O+ R, U; v& F
8 @4 D" w( B* M# E: N- ~9 w3、NC ALAMRE IS BEING GENERATED/ ? c+ }" T' S, X% K) @
0 m+ h, b- h! O d. m
BMI SIGNAL AL....IS ON
# l! B' x% \( h9 C* S3 K) \5 f6 `3 a
CHECK FAULTY DEVICE3 L5 J4 n, n8 ^& U) {# f& V0 D* m- D
% L. r) V: {) Y0 l0 G; w4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF
! m/ h, {; b1 ]5 h( B- |' m- M* T7 Q) b: F
CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC
! R4 }3 N! I4 C) a+ u3 M3 W4 ]/ G/ d5 Q+ u
5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE, c' F7 X! c6 u- r. t
; f- R, W2 L4 ~& u/ l" [! D7 i' ^SELECT CORRECT CODE
. L4 @9 y! S3 P, ?3 l$ _ |
评分
-
查看全部评分
|
发表于 2015-7-30 16:52:32
QQ好友和群
收藏
淘帖
问题专业，描述清楚
伸手党/灌水/看不懂