|
technical characteristics 技术参数* [& F, {" k' Y0 z( G; q
1/intended for transportotion of barreis with titanium sponge 想用来传输钛海绵
7 ?& O4 m1 P" q) S' P* y2/width of operation zone,mm-860 作业宽度860毫米
* y1 B2 M5 [& Q) _1 t' f/length of operation zone,mm-2600 作业长度2600毫米6 l" k; s9 v2 u2 N
4/type-powered conveyor 形式-电动输送带& u f3 X, q r- k) R: [& I
5/reverse operation mode 可以反转6 D5 `* T, H+ X/ y, ^. S
7/conveying speed of a unil load m/s-0.02-0.25 担搁负载时速度.02-0.25米/秒
! L- b" U' H- G4 a0 r9/drive installed power-1.1KW6 驱动1.1千瓦; L& a( p! k3 b# u' Y
10/overall dimensions, length-1000 width-1250 height-470 总尺寸长1000 宽1250 高470毫米1 c' s# `- g' d' T& c
technical requirements 技术要求) _8 T1 Z( Q) B' Z
1/roller conveyor(roll-tabie)shall comprise the following equipment:滚动输送带(辊子工作台)应包含下列设备:5 f' ~' D, ]5 E1 W% M( b$ T
1.1limit switches 限位开关
9 K9 I8 @( l7 ~6 T5 d$ j* p: e/ A- E1.2emergency stop switches 急停开关
! ^, d- M7 P5 N" `2/start-up and protective equipment shall be supplied in a set 启动和保护装置应成套供应+ S) t3 h. U, o
3/start-up and protective equipment shall be mounted on a frame(panel) 启动和保护装置应安装在一个架子或面板上 n! `- T+ B; F6 I0 S4 W& j# l
frame size shall be provided to mount frame with equipment in the switchboard room cabinet 架子的尺寸应可以固定支架安装到控制房的控制柜上- h) z) P; ~& H( z3 |1 h
4/local manual contral and remote automatic contral shall be provided in the start-up equipment control circuit. equipment status signais shall be issued in party B APCS 现场手动控制和远程自动控制应提供在启动设备的控制板上. 设备状态信号应提供到"party B APCS "(不清楚)
7 z8 [9 J! W c5/provide local contral desk, IP54 equipped with mode switch for "L"(local)and"R"remote operation modes. 提供现场控制台 "IP54"(不清楚)提供现场和远程控制的转换开关.
) X8 A3 F, x: |) s; o U; X2 N O4 Q, U
不是很专业,希望能帮上你! |
|