一台德克磨床的英文资料---请教

老军工

Type 1
Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
Type 2
6 u  x2 c6 t8 c( R* z: MFlutes with individual infeeds of depth have the same length ;therefore different points of exit at periphery.
, u0 F% S6 F& E3 k1 V7 `
求助各位老师：本人是数控磨床操作工，

hyj_9766

用网络在线翻译

英德康

原帖由 老军工 于 2008-9-30 20:06 发表
( l* t+ ]( X! |) `Type 1
Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
" t  H$ c; U6 aType 2
Flutes with individual infeeds of depth have the same length ;t ...

老军工你好，对你的专业不熟，译文仅供参考，
+ ]  [) s5 o) w第1类
对于个别横切深度的凹槽，长度不一样但刀边出位一样，
第二类，
& o/ @- Q! d4 t  h! X对于个别横切深度的凹槽，长度一样但刀边出位不一样，