|
|
牧野机床出现以下问题，哪个大神帮忙解决。多谢了！
- b3 J! p0 e$ }4 S0 z% _) e- g/ E% }
机床问题：% ]* k! i, A+ \
5 k9 C. L$ O5 i- h: c9 C. o1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED+ Q8 Q' Z: P* Q9 g0 x% H0 S
5 ?( E8 w" y q2 g
COMMAND S—CODE AFTER RESET ALARM
s* {1 n. z0 Y4 C8 Q2 u( b0 |
% r+ H) Q' v0 A) ]: r& L) ~2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
& k% G. Y" ]1 o* |& M2 h5 N# r8 W B$ d& F
DI SIGNAL TH2... WENT ON
: u& @! ~$ u/ P. @# y0 l ^7 ]7 T* \8 f9 W. q' E1 p. y7 R, B
CHECK THERMAL RELAY AND THE BREAKER
P8 {# K( O' u' q+ _3 C) i& ^; N' V! w$ w) _; S0 g
3、NC ALAMRE IS BEING GENERATED# R. V& k. Q& Z! a& f( g7 n
: t4 O/ z( a7 L w" m. tBMI SIGNAL AL....IS ON
" V# ]/ V' W6 U; J( j/ b. d& K7 [2 \) }" {+ N# s
CHECK FAULTY DEVICE$ S- i# Z2 o, [9 d5 G5 ?$ f
?7 }. ^1 x0 j9 ]1 ?* k4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF
8 G" @' W& n# c- u# S; P
! T# B" v/ o1 A; O. U# i2 qCHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC
8 F }# B4 l, V9 ]: ?) \0 e
- O5 z% ~( M6 E) N5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE
% a8 k4 _( q5 @$ B: n0 A2 D+ r# E
SELECT CORRECT CODE$ S4 s; b9 t6 C5 w ~- J
|
评分
-
查看全部评分
|
发表于 2015-7-30 16:52:32
QQ好友和群
收藏
淘帖
问题专业，描述清楚
伸手党/灌水/看不懂