金属切削仿真中采用自适应网格时出现不能使用单元畸变控制

hlhchina

% |, m  L/ S6 ~  Z
" B8 q" r2 w; O* d# @2 O+ A我在做金属切削仿真，在金属切削仿真中采用自适应网格，但是在网格检查时出现自适应不能使用单元畸变控制！！！
, F8 y3 J3 D, \问题描述如下：
Adaptive meshing is not supported for elements used with the distortion control.
2 o& x$ o+ J- M2 N# U3 h, [) iDomain name: assembly_adapt
6 L1 G: ?; U& |7 q9 kAbaqus/Explicit Packager exited with an error - Please see the  status file for possible error messages if the file exists.
8 r. S1 J- B: A3 W
但是不用网格畸变控制吧，又出现了网格畸变问题：
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
Print-out suppressed for subsequent distorted elements
There are a total of        60 excessively distorted elements.
% Y% a9 [2 a" K3 O请求各位达人帮助，万分感谢！！！

闲庭信步逸

有人回复吗
4 F! h5 g. S6 w; b6 q2 ]

AdaptER

老哥，您这个问题解决了吗？