求翻译

jackline

外语不精，求达人翻译，谢谢

1：垂直度超差：图纸要求Φ125±0.011外圆和端面的垂直度公差0.03mm,实测0.06mm
, _( Y' V; }# U) c
2：平行度超差：图纸要求部件底部装配基准面与装导轨平面平行度0.02mm，实测0.05mm
3：直线度超差：实测导轨止口直线度0.26mm（中凹）
" }5 _$ M& ~  S* {1 S" s5 s4：尺寸超差：  图纸要求 Φ150+0.04孔中心线与底面尺寸为145±0.03mm,实测144.94mm
5：装配基准面有2处补焊，凸0.03mm（长15mm宽5mm）附照片

神奇宝贝

1.Perpendicularity is out of tolerance: drawing's  requirement is Φ125±0.011, perpendicularity tolerance of the outer circle and end face is 0.03mm, fact measurement is 0.06mm.
. P6 b3 |* o1 ]! I& F, a2. Parallelism is out of tolerance: the required parallelism between the bottom assemble datum plane and guide installiaton plane is 0.02mm, fact measurement is 0.05mm.
3 w( H% G, n% n+ ?2 a: y; h' e1 J3. Straightness is out of tolerance: fact measurement of the guide's front edge is 0.26mm(Middle is concave)
5 y7 ^; ^+ }7 t8 g4. Dimension is out of tolerance: drawing's  requirement is Φ150+0.04, distance between the hole center and the bottom is required 145±0.03mm, fact measurement is 144.94mm.
5. There are two repair-welding on the assemble datum plane, protruding 0.03mm(15mm long and 5mm wide), see attached photo.

jackline

回复 jackline 的帖子
6 l5 \: J/ g* s1 n1 F6 {
. _! {9 i  {9 c0 t  p受益匪浅，灰常感谢
还想问个问题：尺寸超差，可以用 Dimension is undersize/oversize,或dimension is not correct表示吗？
; p/ j. H) N  d: T% Q# i

神奇宝贝

jackline 发表于 2011-7-7 20:06
回复 jackline 的帖子
/ Q. s& `5 d8 \4 C' s* Q3 H
: _0 t- R& w6 v% ]) ^- c! z0 Q) Y  Q受益匪浅，灰常感谢

! \, C- h. ~/ y# o, M没用过，也没听别人这样用过

采彡铯莎氵莫

是和公司有关的，又学习了

wugqtop

jackline 发表于 2011-7-7 20:06
4 n9 `; m6 R2 O3 d& @! q9 ], W回复 jackline 的帖子
" \) A# H- I" S& K2 C
受益匪浅，灰常感谢

dimension out of tolerance

kason127

用google翻译好了！！