|
|
牧野机床出现以下问题，哪个大神帮忙解决。多谢了！
B1 f6 P/ n5 `1 j/ |3 R
$ ^# e) v& A6 I p6 v2 ~机床问题：
2 d- o1 z \2 G# |
6 [6 |. [! V6 H9 n6 b+ ~3 A) \1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED$ E7 Z* p5 s9 X! P
2 u. d" t# w5 l" e/ Y: C0 @COMMAND S—CODE AFTER RESET ALARM
, Y2 k9 k( Q2 g+ T- M
) V+ h8 F$ {1 Q A& H2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
/ Q l! E" M, B" o$ w+ @5 B0 [: p* f
; ]8 z* T/ f6 r/ J" RDI SIGNAL TH2... WENT ON+ R( l# U* ~+ h* y# ~2 R* T
4 g9 G9 {+ ]2 o" p- y5 e/ L
CHECK THERMAL RELAY AND THE BREAKER- }* w3 e$ A) f4 t1 E: I% y
' x* ^& W3 _* O) M6 M" E- d6 G
3、NC ALAMRE IS BEING GENERATED5 L3 L$ g; J; {: V% k5 w/ c) p' J0 f
6 e7 q7 c0 {% F% A R1 z+ s( MBMI SIGNAL AL....IS ON
0 o* m' z" B2 N9 D+ L, c- l, t$ H1 z9 J
CHECK FAULTY DEVICE9 p) N+ Y: f# \5 \8 C/ a3 j
! y% K; R8 B, A s2 I' m4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF" i* q3 k2 K1 I5 h8 |! n4 ?
: }2 t& O( d! H0 g `6 Q+ B
CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC
' ]+ l2 b, G8 D( x, Z5 G. n: C! b2 A$ t2 }5 {
5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE- L4 J/ j# ?: q3 [4 I. _
( s, F6 k4 L' V. ]& ~
SELECT CORRECT CODE
: T4 a; a- G+ i% b7 a$ C$ y |
评分
-
查看全部评分
|
发表于 2015-7-30 16:52:32
QQ好友和群
收藏
淘帖
问题专业，描述清楚
伸手党/灌水/看不懂