求翻译

jackline

外语不精，求达人翻译，谢谢

1：垂直度超差：图纸要求Φ125±0.011外圆和端面的垂直度公差0.03mm,实测0.06mm

  C$ Z. c- E/ Z) D9 d9 t" b2：平行度超差：图纸要求部件底部装配基准面与装导轨平面平行度0.02mm，实测0.05mm
3：直线度超差：实测导轨止口直线度0.26mm（中凹）
2 F' i8 V3 i6 o0 J9 H9 Z4：尺寸超差：  图纸要求 Φ150+0.04孔中心线与底面尺寸为145±0.03mm,实测144.94mm
5：装配基准面有2处补焊，凸0.03mm（长15mm宽5mm）附照片
- F( ^( M) i5 J% i

神奇宝贝

1.Perpendicularity is out of tolerance: drawing's  requirement is Φ125±0.011, perpendicularity tolerance of the outer circle and end face is 0.03mm, fact measurement is 0.06mm.
2. Parallelism is out of tolerance: the required parallelism between the bottom assemble datum plane and guide installiaton plane is 0.02mm, fact measurement is 0.05mm.
3. Straightness is out of tolerance: fact measurement of the guide's front edge is 0.26mm(Middle is concave)
4. Dimension is out of tolerance: drawing's  requirement is Φ150+0.04, distance between the hole center and the bottom is required 145±0.03mm, fact measurement is 144.94mm.
' Z7 D; ?) A  k6 C, G! e% R5. There are two repair-welding on the assemble datum plane, protruding 0.03mm(15mm long and 5mm wide), see attached photo.

jackline

回复 jackline 的帖子
3 J! K0 z9 W+ S( i
受益匪浅，灰常感谢
还想问个问题：尺寸超差，可以用 Dimension is undersize/oversize,或dimension is not correct表示吗？

神奇宝贝

jackline 发表于 2011-7-7 20:06
" Y( D. _1 U& E4 J) E' l回复 jackline 的帖子
0 w# M( Y5 u0 a& {
受益匪浅，灰常感谢

4 f% `* U0 |9 _* ~没用过，也没听别人这样用过

采彡铯莎氵莫

是和公司有关的，又学习了

wugqtop

jackline 发表于 2011-7-7 20:06
- t# ?2 u4 c1 x! Q, N9 B- h# c6 f* g, d回复 jackline 的帖子
+ k8 m: F7 H+ F: e6 i( V
1 T6 a& F& y$ m- h受益匪浅，灰常感谢

dimension out of tolerance
( |% S5 }8 Q% T( ~4 Y

kason127

用google翻译好了！！